All as i am putting my mutt together i kept looking for where would the washer jet be at... i had the container, hoses and pump and then a line in the engine, but it was just laying there... so i was able to figure out, my hood must have been a replacement. there is no jet in the hood. from pictures i could see it is in the middle of the hood close to the windshield. however i am not sure how far from the back of the hood it should be. i dont want it too close then it shoots low... to far might not reach it...
can some one tell me how many inches from the back edge of the hood in the middle i should drill a hole for the jet (i was able to buy one on ebay)?
tim
m151a2 windshield washer jet location
Moderators: rickf, raymond, Mr. Recovery
-
Hambone
- Brigadier General
- Posts: 2512
- Joined: October 1st, 2010, 12:19 am
- Location: El Dorado, Arkansas
Re: m151a2 windshield washer jet location
1 3/4" back to center, you can adjust spray angle.
You do not have the required permissions to view the files attached to this post.
Re: m151a2 windshield washer jet location
perfect thanks Hambone