How many exhaust hangers?

[lpcoating]

Doing some PM on my A2. I have an exhaust clamp kit and in the kit there are (2) brackets that go around the pipe for mounting. I looked in the manual (-20 I think) and it only shows the exhaust pipe clamp that is attached to the welded on bracket where the pipe goes through the rear shock mount. I know that one of these brackets is used behind that (towards the tail pipe) and mounts by the rear crossmember. Any idea where the other one is supposed to go? Or does the kit have an extra bracket? This is the bracket that I'm talking about:



Guy

[rickf]

The -20P appears to show one clamp on each end of the second tailpipe before the outlet tip piece. On my A1 there is a bracket welded to the frame facing back just over the pass through hole through the frame and there is a clamp on that. The other one shows at the other end of that pipe right before the tailpipe tip extension. In this diagram from the -20 it appears the same clamp on both spots but that is not true with the welded on piece, Maybe the A2 uses a different clamp right after the pas through? Click on the pic a couple times for a larger view.

mutt exhaust.png

[lpcoating]

So maybe my kit just had an extra hanger for the pipe? I was seeing the same as you posted. Thank you.

Guy

[199th mp]

is there any chance the extra is supplied in order to accommodate the body extension that is used on the M718 version?

[Hambone]

Hanger points, 2 in rear and large clamp around muffler. Glad I looked, one clamp needs rotating.

hanger1.JPG

hang2.JPG