engine dont stops

This is the place to get help with technical matters concerning your M151 jeep

Moderators: rickf, moose53, raymond, Mr. Recovery

Post Reply
svramselaar
2nd Lieutenant
2nd Lieutenant
Posts: 887
Joined: December 30th, 2007, 6:48 am
Location: holland

engine dont stops

Post by svramselaar » April 7th, 2020, 8:06 am

hi

yesterday i drove home made contact off engine dont stops :?
engine keep running like the ignition is on
the contackt switch is ok
at the 60 amps alternator below the cover the thin wire 568 had a bad isolation at the soldering :idea:
a inner wire was to the load cable so the wire no 568 give power to the wireno 12 ignition engine keeps running :D
a new wire at the alternator problem solved :D

this can happen george

rickf
General
General
Posts: 16832
Joined: November 26th, 2007, 1:28 pm
Location: Pemberton, NJ.

Re: engine dont stops

Post by rickf » April 7th, 2020, 8:38 am

I can remember many years ago when alternators were first being used with internal regulators that would happen sometimes same basic problem. Funny how things pop up like that so many years later. Have seen it happen many times with external regulators where the points or a relay would stick on.
1964 M151A1
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone

acudanut
USMC Gunny
USMC Gunny
Posts: 1013
Joined: April 12th, 2011, 12:50 pm
Location: Land of OZ, KANSAS

Re: engine dont stops

Post by acudanut » May 8th, 2020, 3:23 pm

So how did you make the engine quit ?

User avatar
raymond
Major General
Major General
Posts: 3148
Joined: November 26th, 2007, 8:29 pm
Location: God's country, Clarksville Mo.

Re: engine dont stops

Post by raymond » May 8th, 2020, 9:20 pm

Off the top of my head, step on the brake, release the clutch.
Raymond


Fastest 1967 Ford M151A1 in Pike County!!!!!

"Who is John Galt?"

acudanut
USMC Gunny
USMC Gunny
Posts: 1013
Joined: April 12th, 2011, 12:50 pm
Location: Land of OZ, KANSAS

Re: engine dont stops

Post by acudanut » May 9th, 2020, 12:17 am

That's one way !!

Post Reply