WTB fitting for carburetor

Need something for your Mutt? Let us know!

Moderators: rickf, raymond, Mr. Recovery

Post Reply
m270mlrs2
Corporal
Corporal
Posts: 32
Joined: March 21st, 2019, 6:42 am

WTB fitting for carburetor

Unread post by m270mlrs2 » January 25th, 2020, 9:56 am

Good morning I am trying to locate the correct fitting for my M151a2 carburetor. Its the fitting that is on the side where the fuel line come in to the metal filter that is attached to this fitting that is attached to the carb. Thanks for any help.

ELBOW PIPE 90 DEGREE
NSN-4730-01-088-9309
FSCM-19207
PN-11668003

User avatar
rickf
General
General
Posts: 19740
Joined: November 26th, 2007, 1:28 pm
Location: Pemberton, NJ.

Re: WTB fitting for carburetor

Unread post by rickf » January 25th, 2020, 12:38 pm

The 90 degree fitting is for the A1, The 30 degree fitting is for the A2. The fuel lines feed from different directions.
1964 M151A1
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone

User avatar
Mr. Recovery
Brigadier General
Brigadier General
Posts: 2892
Joined: December 5th, 2007, 9:03 pm
Location: New Port Richey, Fl.
Contact:

Re: WTB fitting for carburetor

Unread post by Mr. Recovery » January 25th, 2020, 1:09 pm

m270mlrs2 wrote:
January 25th, 2020, 9:56 am
Good morning I am trying to locate the correct fitting for my M151a2 carburetor. Its the fitting that is on the side where the fuel line come in to the metal filter that is attached to this fitting that is attached to the carb. Thanks for any help.

ELBOW PIPE 90 DEGREE
NSN-4730-01-088-9309
FSCM-19207
PN-11668003
Army Jeep Parts has them listed.

https://www.armyjeepparts.com/p-3882-m1 ... 21892.aspx

Image
1960 M151 Run 1
1963 M151 Willys DoD 10-63 in Baltimore
1989 Alley Cat. "work in Progress"
NRA Life Member
American Legion Post 275 Fl
US Army 6 years 2nd Armored Cavalry Bindlach Germany
Colorado Army Nat. Guard 5 years
Md Air Guard 15 years active duty on C-130's

User avatar
rickf
General
General
Posts: 19740
Joined: November 26th, 2007, 1:28 pm
Location: Pemberton, NJ.

Re: WTB fitting for carburetor

Unread post by rickf » January 25th, 2020, 6:40 pm

He and I have been talking by PM about that one, it will work but is not original and if the nut is not relieved to accept the o-ring you will have to be real careful that you do not cut or smash the o-ring.
1964 M151A1
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone

Post Reply