Fording Intake Tube (Parts Found)

Need something for your Mutt? Let us know!

Moderators: rickf, raymond, Mr. Recovery

Post Reply
Cobra5
Colonel
Colonel
Posts: 1528
Joined: December 5th, 2007, 11:10 pm
Location: Stevensville, Montana

Fording Intake Tube (Parts Found)

Unread post by Cobra5 » July 3rd, 2019, 6:47 pm

Gentlemen,

Anyone have an extra support bar and clamp that secures the intake tube to the dash? I'd rather buy from somebody here than elsewhere.

Thanks!
Tim
Last edited by Cobra5 on July 16th, 2019, 9:52 am, edited 1 time in total.

User avatar
rickf
General
General
Posts: 19740
Joined: November 26th, 2007, 1:28 pm
Location: Pemberton, NJ.

Re: Fording Intake Tube

Unread post by rickf » July 4th, 2019, 8:46 am

I am thinking that it is going to be tough to find just the bar alone but if you don't I would bet someone could give you the dimensions and you could make one from EMT tubing and mash the ends in a vice and drill them. Betting you can't tell the difference from two feet once painted.
1964 M151A1
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone

Cobra5
Colonel
Colonel
Posts: 1528
Joined: December 5th, 2007, 11:10 pm
Location: Stevensville, Montana

Re: Fording Intake Tube

Unread post by Cobra5 » July 4th, 2019, 9:36 am

Rickf glad to see you are back with us, hope all is going well with your recovery. I figured this would be a long shot but you never know what someone might find at a show or have stashed away not thinking that a few misc parts of a kit would be worth anything. I will most likely end up fabricating what I need if no one has anything.

User avatar
rickf
General
General
Posts: 19740
Joined: November 26th, 2007, 1:28 pm
Location: Pemberton, NJ.

Re: Fording Intake Tube

Unread post by rickf » July 4th, 2019, 12:51 pm

I have an entire setup still in the box but needless to say I don't want to break it up.
1964 M151A1
1984 M1008
1967 M416
04/1952 M100
12/1952 M100- Departed
AN/TSQ-114A Trailblazer- Gone

Cobra5
Colonel
Colonel
Posts: 1528
Joined: December 5th, 2007, 11:10 pm
Location: Stevensville, Montana

Re: Fording Intake Tube

Unread post by Cobra5 » July 8th, 2019, 11:50 am

I have a complete kit as well and don't want to break mine up either. I just went ahead and purchased the support rod from the auction site. Now all I need to do is fine the clamp or make one.

Post Reply