Search found 248 matches

by bazookajoe
August 14th, 2019, 9:30 am
Forum: Technical Discussion
Topic: A-2 Fuel Pumps Question
Replies: 11
Views: 385

A-2 Fuel Pumps Question

I was wondering about feedback on replacement fuel pumps for the A-2s. I have two takeoff pumps that the diaphragms have petrified. Are the replacement pumps by Airtex, and who does make them if not,and are they reliable, also does someone offer rebuild kits? thanx
by bazookajoe
July 16th, 2019, 7:27 am
Forum: Technical Discussion
Topic: Overheating Issues
Replies: 10
Views: 385

Re: Overheating Issues

i replaced the thermostat,poured the antifreeze that i drained out.....then added another 3/4 of a gallon,so i guess the coolant level was just low. When i removed the cap and looked in there was coolant in the top tank,just not enough.
by bazookajoe
July 16th, 2019, 7:22 am
Forum: Technical Discussion
Topic: Ignition left on
Replies: 6
Views: 439

Re: Ignition left on

Update...it ran for 10 miles,then died. Coil fried and module fried.
by bazookajoe
July 11th, 2019, 10:34 am
Forum: Technical Discussion
Topic: Overheating Issues
Replies: 10
Views: 385

Re: Overheating Issues

Yes i changed the thermostat, hoses are hot,coolant level correct level,cap holding pressure. I have heard of water pumps leaking ,I just dont see how it wouldnt pump water. I think i will change the thermostat first.Also i can tell its overheating not just inaccurate gauge. I will tell more tomorrow.
by bazookajoe
July 10th, 2019, 10:10 pm
Forum: Technical Discussion
Topic: Overheating Issues
Replies: 10
Views: 385

Overheating Issues

Took my A-2 for a ride tonight "about 9 mi." and noticed it was getting up to 220 degrees. The radiator has been flushed and the antifreeze was up to the proper level. When i took the cap off it didnt seem as though the water was moving. The system was pressurized when i took the cap off so i dont t...
by bazookajoe
July 2nd, 2019, 8:53 pm
Forum: Technical Discussion
Topic: Ignition left on
Replies: 6
Views: 439

Re: Ignition left on

Fortunately she fired right up...and...i also carry an extra distributor.....easy to change out in an emergency...thanx for the tip
by bazookajoe
July 2nd, 2019, 2:38 pm
Forum: Technical Discussion
Topic: Ignition left on
Replies: 6
Views: 439

Ignition left on

If the ignition is left on overnight with an electronic module in the distributor, will this definitely destroy the coil and module? I am charging the batteries now and hope she starts right up.
by bazookajoe
April 15th, 2019, 10:33 am
Forum: Technical Discussion
Topic: Brake Shoes Orientation
Replies: 3
Views: 389

Re: Brake Shoes Orientation

Thank you
by bazookajoe
April 14th, 2019, 11:21 pm
Forum: Technical Discussion
Topic: Brake Shoes Orientation
Replies: 3
Views: 389

Brake Shoes Orientation

OK...going goofy here,I cant find in the T.M.s where it would state if the longer brake shoes go in front or in back. I believe the longer shoes are installed in the back on the Mutt. Yes or No????
by bazookajoe
March 17th, 2018, 8:42 am
Forum: Technical Discussion
Topic: Magnesium Wheels
Replies: 17
Views: 2135

Magnesium Wheels

What years were the magnesium wheels installed on the m151 series. Were they only on the straight 151's?
by bazookajoe
January 17th, 2018, 9:06 pm
Forum: Technical Discussion
Topic: Differential suppliers
Replies: 2
Views: 775

Re: Differential suppliers

I agree wholeheartedly Rick, i too have swapped out an early diff for a later one and no difference in noise.
by bazookajoe
January 17th, 2018, 9:03 pm
Forum: Technical Discussion
Topic: Transmission Suppliers
Replies: 2
Views: 673

Re: Transmission Suppliers

I have an early take out A-1 or straight 151 engine that has a Muncie Indiana tranny attached to it and a few take out A-2 engines with Howa Machinery Corporation of Japan trannys attached. The engines are standard bill of fare. I always thought the Howa's were a good tranny, but because of our invo...
by bazookajoe
January 17th, 2018, 6:13 pm
Forum: Technical Discussion
Topic: Differential suppliers
Replies: 2
Views: 775

Differential suppliers

151 A-1 differentials had a prefix number 8 and the A-2 number started with 11, Is there a difference at all between the two? I was also wondering who made these units. I see some replacement units built in Korea,are these quality units. I would assume so.
by bazookajoe
January 17th, 2018, 6:09 pm
Forum: Technical Discussion
Topic: Transmission Suppliers
Replies: 2
Views: 673

Transmission Suppliers

I know that early trannys were made by Muncie and later trannys were made by Howa but i was wondering what other suppliers made transmissions for 151s.
by bazookajoe
December 7th, 2017, 3:49 pm
Forum: M151 For Sale
Topic: M151 A-1 Engines with and W/O transmissions
Replies: 2
Views: 801

Re: M151 A-1 Engines with and W/O transmissions

I am located in Syracuse NY.